F-V TYPE
(BASIC TYPE WITH HOLLOW SHAFT)
Standard design of TEIKOKU Motor Pump. Most commonly used for a wide variety of applications. Internal circulation through hollow shaft requires no external
piping. |
FA-V
TYPE
(BASIC TYPE WITH HOLLOW SHAFT)
Standard design of TEIKOKU Motor pump, but with adapter to
increase motor and pump combinations. |
 |
 |
|
RW
/ RV Type (Reverse Circulation)
Vertical installation improves venting and minimizes bearing
loads, recommended for low viscosity and high vapor
pressures.
FW / FV Type (Hollow Shaft) Design with internal
circulation, no outside piping required |
R
TYPE
(REVERSE CIRCULATION)
Suitable for handling volatile fluids such as Ammonia
, Freon, and other liquified gases, just as very low NPSH
applications. |
 |
 |
|
K-S
TYPE
(FULL HEATING JACKET TYPE)
Suitable for handling fluids with high melting points. |
K
TYPE
(FULL HEATING JACKET TYPE)
Similar to K-S type, but for fluids with lower melting point. |
 |
 |
|
D
TYPE
(SLURRY SEAL TYPE)
Suitable for handling fluids containing small amounts of
fine solids. With mechnical seal to prevent solids from
entering motor cavity. |
XG
TYPE
(GAS SEALED SLURRY TYPE)
Handles fluid with considerable slurry. Besides XG-type,
SG-type with external flushing is also available. |
 |
 |
|
G
TYPE
(SELF-PRIMING TYPE)
Used for pumping fluids from underground tank or rail/tank
truck unloading. |
F-M
TYPE
(MULTI-STAGE TYPE)
Higher head, higher efficiency pump. Besides F-M type, R-M
(Reverse Circulation) type and B-M (High Temp-Insulation)
type are also available. |
 |
 |
|
TYPE
B
(HIGH
TEMPERATURE DESIGN)
Suitable for handling high temperature fluids, such as heat
transfer oils. Circualtion with external heat exchanger and
motor jacket for cooling. |
TYPE
X
(HIGH
TEMPERATURE DESIGN)
Suitable for handling high temperature fluids. Special motor
coil insulation does not require any cooling jackets or heat
exchanger. Therefore, space demand is very low. |
 |
 |
|
L
TYPE
(ABSORPTION CHILLER)
Special design for the use in Absorption Refrigeration.
Internal circulation through hollow shaft requires no
external piping. With inducer as standard to obtain low NPSH
value. No base plate - pump directly mounted to the piping. |
 |
inviaci un e-mail
inviaci un fax al n. 
chiamaci al n. 
